恩施附近有没有服务

Hello, welcome to Ningjin Shengda baler machinery factory!

Add to collection | About us | contact us | Website map

 Waste paper packer

National hotline thirteen billion one hundred and forty-five million three hundred and forty-four thousand and one hundred

Current location: Baler > news information >

Detailed process of operation specification for automatic waste paper packer

Author: admin Release time: 2020-07-13 10:58 Number of visits:

Automatic waste paper packer is widely used, Automatic waste paper packer The common sense of equipment operation, automatic waste paper packer equipment health problems are everyone's attention. There is no end to the question of operation standard. We should take time to pay attention to it. Otherwise, we will lose a lot. Everyone pays attention to the operation specification of automatic waste paper packer. Of course, there is no exception in the process of using the automatic waste paper packer.

Operation specification process of automatic waste paper packer:
Before starting, check whether the appearance of the equipment is abnormal, whether there are health hazards around, and whether the iron wire or plastic rope is sufficient. After confirming that it is normal, turn on the main air switch of the distribution box, release the pop-up emergency stop button, and the power indicator light of the electric control box is on. Turn the remote local gear selection switch to the remote control gear.

Put the magnetic switch on the remote control into the card slot, press the system start button on the remote control twice, stop the preparation of the warning equipment after the siren rings for 10 seconds, and the red alarm light is always on. Automatic waste paper packer Shengyuan mining machinery. Press the start button of the conveyor belt on the remote control, the conveyor belt will work, push the paper sheet or other data into the material port, and the conveyor belt will bring the material into the packing inlet.

      After the paper or other materials arrive at the position, press the remote control on the tightening button, and the red alarm light will flash. After the indenter is pressed in place, the active retreat stops. (if the indenter moves to a certain position after the compression is started, it does not stop and returns to its original position after tens of seconds, the alarm siren will give an alarm at the frequency of 1 second. At this time, the active arm alarm type point presses the upper arm of the remote control to loosen the arm And then start tightening until it is normal and no alarm is given.
 Automatic waste paper packer

For the manual arm type, press the two ends of the arm with a jack, rotate the two screws at the same distance into the arm, and then start tightening until the alarm is normal. Repeat 4 operations until the required packing length is reached, press and hold the bundling button on the remote control for 2 seconds, and then the equipment will start up actively. When the pressure head advances to the front packing position, it will stop, and the alarm siren will give an alarm at a frequency of 3 seconds.

Press the remote control. Put on the threading button, and the threading machine will take the initiative to return to the original position after threading the iron wire or plastic rope. Tie the iron wire or rope and cut it. One package is finished. Repeat the above procedure. The package at the exit will be pushed out by one package, and the product package will be moved to the appropriate address by holding truck or forklift truck, and the package will be placed orderly. After the work is completed, press the remote control system stop button, shrimp magnetic switch, press the emergency stop switch of the electric control box, and close the main power supply.

Shengda Machinery in line with the quality assurance, customer first, and has always followed the quality policy of being responsible for each process, each product and every user, and wholeheartedly serves the users.