恩施附近有没有服务

Hello, welcome to Ningjin Shengda baler machinery factory!

Add to collection | About us | contact us | Website map

 Waste paper packer

National hotline thirteen billion one hundred and forty-five million three hundred and forty-four thousand and one hundred

Current location: Baler > news information >

What is the operation process of waste paper packer?

Author: admin Release time: 17:07, September 10, 2020 Number of visits:

The quality of hydraulic oil used in waste paper packer directly determines whether the oil cylinder can play a great role, and also directly affects the failure rate and service life of the oil cylinder. 46 anti-wear hydraulic oil is needed to ensure the effective production of baler. The direct influencing factors of the production efficiency of waste paper packer: the production efficiency of the baler is directly determined by the different models, different output and different specifications. The production efficiency of the conventional waste paper packer is higher than that of the packer with a door at the outlet. Operation process of waste paper packer:

 Construction of waste paper packer

1. Before starting the machine, check whether the appearance of the equipment is abnormal, whether there are potential safety hazards around, and whether the iron wire or plastic rope is sufficient. After confirming that it is normal, turn on the main air switch of the distribution box, release the pop-up emergency stop button, and the power indicator light of the electric control box is on.

2. Turn the remote local gear selection switch to the remote control gear.

3. Put the magnetic switch on the remote control into the card slot, press the system start button on the remote control twice, stop the warning equipment after the siren rings for 10 seconds, and the red alarm light is always on.

4. Press the start button of the conveyor belt on the remote control, the conveyor belt will run, push the paper sheet or other materials into the material mouth, and the conveyor belt will bring the material into the packing inlet.

5. When the paper or other materials arrive at the position, press the compression button on the remote control, the red alarm light will flash, and the indenter will automatically retreat and stop after pressing in place (if the indenter moves to a certain position after the compression starts, it will not stop and will return automatically after tens of seconds, and the alarm will alarm at the frequency of 1 second when returning, At this time, the automatic arm type point press the remote control to loosen the arm holding, and then start the compression until it is normal and no alarm is given. For the manual arm type, press both sides of the arm with a jack, rotate the screws on both sides at equal distance, and then start compression until the alarm is normal).

 Real shot of waste paper packer

6. Repeat 4 operations until the required packing length is reached, press and hold the bundling button on the remote control for 2 seconds, and then the equipment will start automatically. When the pressure head advances to the front bundling position, it will stop, and when it is in place, the siren will give an alarm at a frequency of 3 seconds.

7. Press the threading button on the remote control, and the threading machine will automatically thread in the iron wire or plastic rope, and the threading machine will automatically return to the original position.

8. Tie the iron wire or rope and cut it off. One package is finished.

9. Repeat the above 4-8 procedures. The bags at the outlet will be pushed out one by one, and the finished packages will be moved to the proper place by holding truck or forklift truck.

10. After the work is finished, press the stop button of the remote control system, take down the magnetic switch, press the emergency stop switch of the electric cabinet, and turn off the main power supply.